Written scope
What failed and what we will repair
Skylight Leak Repair Alhambra CA starts with finding the real entry point, not guessing at the glass. We inspect the curb, flashing, sealant, and roof deck around every unit, then repair the failure so water stops reaching your ceiling. If you have been searching for skylight leak fixing in Alhambra, we handle both the roof-side repair and the interior water damage trail it leaves behind.
Every skylight repair starts with a full inspection and ends with a water test. Here is what is covered in a standard repair and what we handle separately if the damage goes further than the roof.


We repair skylights on houses, bungalows, and two-story homes across Alhambra. You get the roof-side failure fixed and a clear answer on any interior water damage.
We repair skylights on commercial buildings and mixed-use properties without disrupting your tenants. Work is scheduled around business hours and building access.
Skylight Leak Repair Alhambra CA is the process of locating and sealing the exact point where water enters around a skylight, then restoring the roof assembly so it sheds water again. Most leaks do not come through the glass. They come through the curb, the step flashing, cracked sealant, or a failed underlayment lap. We pull the surrounding shingles or membrane back, check the framing for rot, and rebuild the waterproofing layers in the correct order.
In Alhambra, skylights sit on roofs that bake through long dry summers and then take concentrated rain between November and March. That swing dries out sealant, shrinks flashing laps, and opens gaps you never see from the ground. If you have been hunting for skylight leak fixing near me Alhambra and watching a brown ring spread across your ceiling, the source is usually a curb detail that failed quietly months ago.
Find where the water actually enters, fix that detail, then prove it with a water test.
Five steps, no surprises. You know what we found, what we are doing, and what it costs before we start swinging a hammer.

Shows temperature differences that reveal where water sits under the roof surface, so we can trace a skylight leak to its full extent before we open anything up.

Confirms how wet the decking, insulation, and drywall are around the skylight. Readings tell us whether the damage is surface-level or has soaked deeper into the assembly.

Gets us safely onto steep-slope and two-story roofs. OSHA safety certification covers the setup, so the inspection and repair happen without risk to the crew or your roof.

Lifts shingles and membrane cleanly around the skylight so we can access the flashing and underlayment without tearing up the surrounding roof field.

Applies Henry roof cement and DAP sealant in controlled beads at the curb joints and flashing edges. The right product for the roof material is what makes the seal last.

Floods the repaired area in stages so we can watch for leaks from inside. This is the step that proves the repair works before we leave the roof.

Covers an active skylight leak during a storm to stop water intrusion immediately. The tarp stays until the roof is dry enough for the permanent repair.

We run water over the skylight starting low and working up, one section at a time. This isolates the exact failure point instead of soaking the whole area and guessing. It is the most reliable way to diagnose an intermittent skylight leak.
We inspect the skylight curb, flashing, and surrounding roof, trace the leak with a moisture meter, and repair the failure. If the drywall is wet, we tell you what to watch for as it dries. The leak stops, the stain stops spreading, and you know whether the drywall needs patching or just drying time.
We open the repair area, find what the previous patches missed, and rebuild the flashing and underlayment correctly. Most repeat skylight leaks come down to a flashing lap that was never reset. A repair that holds through the rainy season, with photos of what was actually wrong.
We tarp the skylight and surrounding roof to stop the intrusion, then schedule the permanent repair once the weather clears and the roof is safe to walk. The water stops, your ceiling and insulation are protected, and the permanent fix is on the calendar.
We inspect the skylight, document its condition with photos, and repair any active failure. If the unit is sound, we tell you that too, so you are not paying for work you do not need. A clear answer on the skylight condition, with repair documentation you can pass to the other side of the transaction.
We repair the membrane around the skylight, reseal the curb termination, and check the drainage path so water moves off the roof instead of sitting at the unit. The ponding stops working into the skylight detail, and the flat roof section drains the way it should.
Alhambra roofs take a beating from dry heat and then concentrated winter rain. That cycle dries out sealant, shrinks flashing laps, and opens gaps around skylights that you never see until water shows up inside. Most of the homes we work on were built between the 1920s and the 1960s, with original framing and roof pitches that were not designed for modern skylight units. We see a lot of clay tile and asphalt shingle roofs, plus flat membrane sections on commercial buildings along Valley Boulevard. When you call for affordable Skylight Leak Repair Alhambra CA, we inspect the unit, trace the leak with a moisture meter, and repair the failure with materials matched to your roof. We work across Los Angeles County and know the local building stock, so we are not guessing at what is under the shingles.
A homeowner near Alhambra Park had a ceiling stain spreading under a skylight for two months. Two previous attempts had sealed the glass, which was not the problem. The curb flashing had rusted through, and water was running straight into the roof deck.
We replaced the rusted flashing with new metal, replaced the wet underlayment, and resealed the curb. The water test ran clean on the first pass. The ceiling stain stopped spreading, and the homeowner patched the drywall two weeks later.
Check the curb flashing and sealant each fall before the rainy season. A five-minute look from the roof can catch a failing seal before it becomes a ceiling leak.
A commercial building had water dripping into a tenant space from a skylight on a flat TPO roof. The membrane around the curb had separated at a seam, and water was getting under the membrane and running along the deck.
We repaired the TPO membrane around the skylight, re-welded the seam, and resealed the curb termination. The tenant space stayed dry through the next storm. The repair took one day and did not disrupt building operations.
Have the flat roof inspected each spring for seam separation and ponding. Catching a lifted seam early prevents water from getting under the membrane.
A Monterey Park homeowner only saw the leak during heavy rain, so it was hard to catch. The skylight looked fine from the ground. We used a thermal camera and found water entering at a shingle lap uphill, running sideways, and showing up at the skylight.
We repaired the actual failure uphill, checked the skylight while we were on the roof, and water-tested both areas. The leak stopped, and the homeowner avoided replacing a skylight that was never the problem.
After any heavy storm, look for lifted or cracked tiles near the skylight. A quick visual check can catch a small failure before it becomes a ceiling leak.
Skylight leaks show up in different ways, and each one points to a different failure. Here are the problems we see most often and how we fix them.

We trace the water to the skylight curb or flashing, repair the roof-side failure, and water-test it. Then we advise on the interior drywall and insulation so the damage does not spread or come back. Water soaking drywall and insulation feeds mold within 24 to 48 hours and can rot the framing above the ceiling.

We run controlled water over the skylight in stages to reproduce the leak on demand. That lets us pinpoint the exact failure and repair it, instead of sealing everything and hoping. Intermittent leaks are the hardest to catch, and they quietly saturate the attic between storms without showing a stain until damage is advanced.

We remove the failed sealant completely, clean and prep the surface, and apply new product rated for your roof material. We also check the flashing underneath, because cracked sealant often hides a bigger flashing problem. Cracked sealant lets water straight into the curb joint, and the leak gets worse every season as the crack widens.

We repair the membrane around the skylight, reseal the curb termination, and check the drainage path so water moves off the roof instead of sitting at the unit. Ponding water at the skylight curb works into seams and terminations, and it can eventually find its way into the building.

We replace the damaged flashing with new metal, reset the laps, and replace any underlayment that got wet. The repair restores the waterproofing layers in the correct order so the skylight sheds water again. Rusted flashing loses its seal and lets water under the shingles, which can rot the roof deck around the skylight.
We use an infrared thermal imaging camera and a moisture meter to follow the water path instead of guessing. That means we repair the actual entry point, not the stain on your ceiling. Most misdiagnosed skylight leaks we reopen were sealed at the glass while the real gap sat at the curb flashing.
Water that reaches drywall or attic insulation starts feeding mold within about 24 to 48 hours. We stop the intrusion, then check the surrounding decking and insulation for saturation. Catching it early keeps a $300 repair from turning into a $3,000 drywall and insulation replacement.
We match the repair to what is already up there: asphalt shingles, clay tiles, slate tiles, or a TPO membrane on a flat section. Henry roof cement, DAP sealant, and Grace underlayment go on where they belong. Wrong sealant on the wrong surface is why so many skylight patches fail in under a year.
When a storm is pushing water through your skylight, we can tarp the area and stop the damage before the full repair. Emergency Skylight Leak Repair Alhambra CA calls get priority, and we schedule the permanent fix as soon as the roof is safe to walk.
Clear records you can keep and share.
What failed and what we will repair
Before and after images of the work
Confirmation the repair holds before we leave
Most skylight leaks do not come through the glass. They come through the curb, flashing, or sealant around the unit. Knowing where to look saves you from replacing a skylight that was never the problem.
Skylight glass is tough and rarely fails. The leak almost always starts at the curb, flashing, or sealant joint. Sealing the glass is the most common wasted repair we see.
A leak that only shows in heavy rain can still be reproduced with staged water testing. We run water over the unit in sections until the entry point shows itself.
Water entering uphill of a skylight can run along the deck and drip at the skylight. The stain location is not always the leak location, which is why we trace the full path.

Not sure if we cover your area? Call and ask. (626) 640-8498
Most skylight leak repairs in Alhambra run $350 to $1,200 depending on the failure. A simple reseal and flashing repair sits at the low end. Rebuilding a rotted curb, replacing underlayment, or matching clay or slate tiles pushes it higher. Emergency tarping is a separate smaller charge. We give you the number before we start, and it holds unless we open the roof and find hidden rot.
The most common cause is failed flashing or cracked sealant at the curb, not the glass itself. Alhambra's dry summers bake sealant until it shrinks, then the first heavy rain finds the gap. Other causes include a rusted curb, a nail popped through the underlayment, or a shingle lap that lifted. We run controlled water over the unit to pinpoint which one it is.
We do, and we are set up for it. Roof Repair Alhambra Pros handles skylight leak fixing across Alhambra and nearby San Gabriel, Monterey Park, Rosemead, San Marino, Temple City, South Pasadena, Pasadena, and El Monte. We carry the flashing, underlayment, and sealant needed for shingle, tile, slate, and flat membrane roofs, so most repairs finish in a single visit.
Yes, once we stop the water at the roof. A ceiling stain is the symptom; the skylight curb is usually the cause. We repair the roof-side failure first, then check the attic and drywall for saturation. If the drywall is wet, it needs to dry or be replaced, but the leak itself stops the moment the roof detail is sealed and water-tested.
Water through a skylight gets worse with every storm. Call us, and we will inspect the unit, trace the leak, and give you a straight price before we start. State-licensed roofing contractor serving Alhambra and Los Angeles County.
Call us at (626) 640-8498 or email info@roofrepairalhambrapros.com. We answer the phone during business hours and respond to emergency calls after hours. Same-day estimates are available for most jobs in Alhambra and surrounding areas.